Skip to main content
Are you looking for...
the manual

Lightener / Bleach in Foils

  1. Mix Lightener and developer together.
    • For 1-2oz (30-60g) of Lightener powder (not including developer), add 1/8oz (3.75ml) OLAPLEX No.1 BOND MULTIPLIER. Do NOT bump developer.
    • For less than 1oz (30g) of Lightener powder (not including developer), add 1/16oz (1.875ml) OLAPLEX No.1 BOND MULTIPLIER. Do NOT bump developer.
  2. Use attached dosing dispenser to measure correct amount of OLAPLEX needed.
  3. Add OLAPLEX to your premixed Lightener and mix thoroughly.
  4. Apply and process as usual.
  5. Rinse and shampoo lightly (we recommend using OLAPLEX No.4 BOND MAINTENANCE SHAMPOO).
  6. Apply OLAPLEX No.2. Leave on a minimum of 10 minutes.
  7. Rinse, shampoo and condition. We recommend using OLAPLEX No.4 BOND MAINTENANCE SHAMPOO and OLAPLEX No.5 BOND MAINTENANCE CONDITIONER for best results.

NOTE WHEN USING A TONER: After step 5, mix Toner with the recommended amount of OLAPLEX No.1. Apply and process as usual. Rinse then proceed with Step 6.

previous

algolia-ignore

MIXING CHART
next

algolia-ignore

USE WITH DIRECT DYES & FASHION COLORS